Rail Height Measurement Device RHM840-2

The measuring device RHM840-2 is used for determination of material removals in the Rails by comparison measurements before and after grinding. The calculated differences result in the removal of the material.

Because the rail surface is a certain surface ripple, we recommend the installation ofat least three plates per track.

The Rails would these plates must be installed prior to the editing and remain in their place. To do this is to note that the plates are tight to the rail foot.

After the end of the Rails can the removal measurements are carried out and then the measurement plates are made.

It is possible on the rail head at multiple locations making measurements.

Thus, it is possible to determine the removal of material over the entire width of thehead.

The measurement data can be read from or transferred via a USB/Bluetooth interface to a connected PC or tablet. To do so, the supplied software of the dial gauge must be installed.